Mechanical Centrifugal Compressor Training


42-70 m3/min (1800-2350 cfm)Centac

The equipment used in these courses has been evaluated as Hazard Risk Category 1 (HRC-1). In accordance with NFPA 70E standards, HRC-1 rated equipment requires the following PPE for personnel working inside the arc flash boundary: Fire Retardant clothing (rated HRC-1 or 4 cal), rubber gloves, safety glasses, and hard hat.


Attendees must be wearing appropriate protective clothing as specified. For those traveling by air, we can provide a limited number of hard hats with arc face shields if required, rubber/leather gloves and safety glasses. If driving, please bring your own PPE.

Any student who fails to comply will not be allowed in the lab areas for any hands-on training portion of this class.

C400 Basic Centrifugal Class
2014 Dates:   Feb 18-20, Apr 29-May 1, Jul 29-31, Oct 21-23

Duration: 3 days
Cost: $2100 per person
Description: This course is designed to provide maintenance, engineering and operations personnel with an overview of the Centac centrifugal compressor.

Agenda:

  • Day 1:  Principles of operation, airflow, hydraulic flow, identification of mechanical and electrical components, control panel with amperage software
  • Day 2:  Routine service and maintenance, basic troubleshooting techniques
  • Day 3:  Disassembly, assembly and calibration of rotor assemblies (type 1-2-3 & 6)

C401 Advanced Centrifugal Class
2013 Dates:   Mar 17-21, Apr 21-25, Jul 21-25, Oct 27-31

Duration: 5 days
Cost: $2,900/person
Description: This course is designed to provide maintenance, engineering, and operations personnel with an in-depth overview of the Centac centrifugal compressor.

Agenda:


  • Day 1:  Basic compressor principles, principles of operation of centrifugal compressors, identification of mechanical and electrical components, control panel with amperage software
  • Day 2:  Hands-on activities include disassembly of complete Centac airend and evaluation of components, verification of the running gear system, installation of rotors and setting rotor clearances
  • Days 3 - 5:  Hands-on activities continue with installation and assembly of the running gear and rotor assesmbly components, and rotor assembly component calibration

© 2014 Ingersoll Rand. All rights reserved.